The Alban Systems Solutions Group (SSG) Technicians offer a full line of advanced electrical services for every facility.
SSG also has your testing and maintenance of automation and mission critical power components covered. Our Technician comes out to you and we can look after;
- Automatic Transfer Switches (ATS)
- Uninterrupted Power Systems (UPS)
- Power Distribution Units (PDU)
- Generator controls
- and much more
Our skilled SSG Engineers can perform power system studies, system design, coordination, metering studies, electrical diagrams, equipment maintenance, acceptance testing, modification, commissioning and start-up.
Maintenance & Testing
Our Alban Field Technicians come to you, minimizing and preventing any downtime your systems by performing vital tests on your equipment.
Applications: UL891, UL1558 and UL MX Switchgear from 208VAC to 35K VACNicholaSor
All our Field Engineers are trained and qualified to support to the most recent standards regarding maintenance and testing for switchgear. From simple Service Entrance and distribution to multiple Utility and Generator Paralleling Switchgear.
- Circuit Breakers (up to 35KV)
- Protective Relays Maintenance to reduce Arc Flash
- Voltage Transformers
- Current Transformers
Automatic Transfer Switches (ATS)
The ATS is one the most important components of your emergency power system, a functioning Generator is useless if the ATS fails. Because of the importance of this component SSG recommends regular scheduled maintenance to test the installation, troubleshoot and maintain.
- Connection checks
- Voltage, Contact Temperatures and Time Delay settings checked.
- Contact resistance calculated
- Clean ATS Enclosure
- Transfer power to ensure proper function of the ATS
- Onsite upgrades
All ATS maintenance is performed at your facility by our SSG Field Engineers.
Uninterruptible Power Systems (UPS)
Alban Power Systems has one of the largest field populations of kinetic energy UPS system. We are an Authorized Service Provider (ASP) for Toshibi and Misubishi units, as well as all CAT UPS units. Our SSG Field Engineers are trained on the most recent standards for all UPS equipment.
We perform maintenance and testing on;
- Insulated-Gate Bipolar Transistors (IGBTs)
- Silicon-Controlled Rectifer (SCR)
- Battery Systems
- Circuit Breakers
- Protective Relays
- Voltage and Current Transformers
Battery Maintenance & Testing
Applications: UPS, Control Panel, UL891, UL1558, UL MV Switchgear & Engine Cranking Batteries
Battery failure is one of the leading causes of downtime with Mission Critical Power Systems. Your facility is compromised when the state of your battery cells are unknown.
SSG Field Engineers can insure proper Battery Maintenance to industrial standards to ensure critical power is available when you need it.
- IEEE recommended testing and maintenance
- IEEE load bank testing
- Thermography on all accessible connections
Let SSG help you maximize the return on your battery investment.
Thermography or insulation testing is how we insure power cables, windings, bus duct, circuit breakers, transformers, control writing, really any device or structure where heat could be an issue, is operating within acceptable limits.
Using this information you can establish trending patterns to predict the life cycle of your components and proactively plan for emergency outages, by turning them into maintenance downtime. Thereby reducing cost and wear on your equipment.
SSG Field Engineers have been trained on the most recent standards in thermography testing.
- Dielectric Absorption Ratio
- Dielectric Breakdown Test
- Dielectric Withstanding Test
- Insulation Resistance Test
- Polarization Index
- Step Voltage
- Dielectric Discharge
- Historical Trending of Electrical Test
Compliance and Regulatory Services
SSG can be your resource for compliance needs, we can help you sort through the requirements and standards, and make practical solutions to address any issues.
For more information
use the form below to contact: