Chat with us, powered by LiveChat

Starting Small... Building Big! With Alban CAT Construction Equipment...

Learn More
3512B Offshore Generator Set Specifications
Minimum Rating 1100 kV·A
Maximum Rating 1943 kV·A
Emissions IMO Tier I
Aspiration Turbocharged-Aftercooled

Engine Specifications

Minimum Rating
1100 kV·A
Maximum Rating
1943 kV·A
Emissions
IMO Tier I
Aspiration
Turbocharged-Aftercooled
Fuel System
EUI
Oil Change Interval
1000.0 hr
Stroke
7.5 in
Bore
6.7 in
Displacement
3175.0 in3
Engine Control
ADEM A3
Weight
33014 lb
Aspiration
Turbocharged-Aftercooled
Bore
6.7 in
Displacement
3175 in³
Fuel System
EUI
Oil Change Interval
1000 h
Stroke
7.5 in

Dimensions

Length
190.6 in
Height
86.9 in
Width
78.3 in
Height
86.9 in
Length
190.6 in
Width
78.3 in

Capacity for Liquids

Cooling System (Engine)
106.0 gal
Lube Oil System (Refill)
84.0 gal
Cooling System - Engine
106 gal (US)
Lube Oil System - Refill
84 gal (US)
  • AIR INLET SYSTEM
    • Separate Circuit aftercooler core, corrosion resistant coated(air side)Air cleaner, regular dutyDual Turbochargers, 152 mm (6 in) OD straight connection
  • CONTROL SYSTEM
    • Caterpillar A-III Electronic Engine Control, LHwith Electronic Unit Injector Fuel SystemRigid Wiring Harness(10 amp DC power required to drive Electronic Engine Control Module)
  • COOLING SYSTEM
    • Outlet controlled thermostat and housing, full opentemperature 92°C (198°F)
    • Jacket water pump, gear driven
    • Single water outlet connection, includes flange:143 mm (5.6")
    • Aftercooler fresh water cooling pump (SCAC), gear drivencentrifugal
    • SCAC pump circuit contains a thermostat to keep theaftercooler coolant from falling below 30°C (85°F)
  • EXHAUST SYSTEM
    • Dry gas tight exhaust manifolds with heat shieldsDual Turbochargers with watercooled bearings and heat shieldsExhaust outlet, vertical, 203 mm (8 in) round flanged outlet
  • FLYWHEELS & FLYWHEEL HOUSINGS
    • Flywheel, SAE No. 00, 183 teethFlywheel housing, SAE No. 00
  • FUEL SYSTEM
    • Fuel filter
    • Fuel transfer pump
    • Electronically Controlled Unit Injectors
    • Fuel priming pump, LH
    • Rigid fuel return line with customer connection point asbase of engine
  • INSTRUMENTATION
    • Overspeed shutdown notification light, Emergency stop notification light
    • Graphical Unit (Marine Power Display) for analog or digital displayof:
  • LUBE SYSTEM
    • Crankcase breather, top mounted
    • Oil cooler
    • Oil filter and dipstick, LH
    • Oil pump, gear-type
    • Oil pan drain valve, 2" NPT female connection
  • PROTECTION SYSTEM
    • A-III Electronic Monitoring System provides customer programmableengine de-ration strategies to protect against adverse operatingconditions
    • Emergency stop push button (located in Electronic Instrument Panel)Safety shutoff protection:
  • STARTING SYSTEM
    • Air starting motor, RH, 620 to 1034 kPa (90 to 150 psi),LH control
    • Air silencer
  • GENERAL
    • Paint, Caterpillar yellow, with black rails
    • Vibration damper and guard
    • Lifting eyes
    • Engine and generator, three-point mounted to sub-base
    • Lift provisions on base
    • Oil drain extension
    • Engine length drip pan
  • AIR INLET SYSTEM
    • Remote Air Inlet Adapters
  • CHARGING SYSTEM
    • Battery Chargers
    • Charging Alternators
  • CONTROL SYSTEM
    • Load Sharing module
    • Local speed throttle control
    • Direct rack control interface, 0-200 mA DC control
  • COOLING SYSTEM
    • Coolant level sensors
    • Connections
    • Air separator
  • EXHAUST SYSTEM
    • Flexible fittings
    • Elbows
    • Flanges
    • Flange and exhaust expanders
    • Mufflers
  • FUEL SYSTEM
    • Fuel Cooler
    • Primary fuel filter
    • Fuel filters
    • Duplex fuel filters
    • Fuel level switch
  • GENERATOR ATTACHMENTS
    • Air filter — generator
    • Bearing temperature detectors
    • Cable access box
    • Manual voltage control
  • INSTRUMENTATION
    • PL1000T Communication Module
    • PL1000E Communication Module
    • Customer Interface Box
    • Remote panel display
    • Remote cylinder temperature display
    • Exhaust temperature thermocouples
    • Discrete I/O module
    • Intake manifold temperature sensors
    • Oil temperature sensor
  • LUBE SYSTEM
    • Duplex oil filter
    • Bypass centrifugal oil filter
    • 500-hour oil pan
    • Emergency lube oil connections
    • Oil level regulator
    • Prelube
    • Sump pump
  • MOUNTING SYSTEM
    • Vibration isolators
  • POWER TAKE-OFFS
    • Auxiliary drive shafts and pulleys
  • STARTING SYSTEM
    • Air or electric starting motor
    • Redundant start with select switch
  • PROTECTION SYSTEM
    • Spray shielding
    • Crankcase explosion relief valve
    • Metal particle detector
  • GENERAL
    • Jacket water heater